Home

Tayana
""
Tayana 52

DETAIL SPECIFICATION

HULL

  • One piece cast iron ballast encapsulated
  • PVC foam sandwich construction
  • Hand laid up FRP hull white, with blue cove stripe & boot top

DECK/HARDWARE

  • Hand paid up FRP, cored deck, white
  • Molded nonskid on deck and deck house
  • Teak cockpit seats and floor
  • FRP cockpit coaming
  • Aluminum hatches
  • Stainless steel opening ports
  • Teak exterior handrails
  • Six mooring cleats
  • Double anchor sprit & rollers
  • Chain locker & one deckpipe
  • SS bow pulpit
  • SS stern pulpit
  • Teak caprail on FRP bulwark
  • Dorade vents w/ FRP boxes
  • FRP seahood
  • Propane locker for two 20 lb tanks, vented overboard
  • Lazaret hatch
  • Two coaming lockers
  • Aluminum mainsheet traveler w/ roller car
  • Aluminum staysail tracks w/ cars
  • Aluminum genoa tracks w/ cars
  • Plexiglas sliding companionway hatch
  • Teak or plexiglas weather boards
  • SS stanchion w/ vinyl covered double lifelines w/gates P&S
  • Winches, Lewmar
    Two 58CST jib sheet winches
    Two 40CST secondary sheet winches
    One 40CST main sheet winch
    One 40CST main halyard winch
    One 40CST jib halyard winch
    One 30CST staysail halyard winch

ENGINE/MACHINERY

  • Engine cooling water intake strainer
  • Dripless shaft gland
  • Bronze three blade propeller on 1.5 inch SS shaft
  • Fiberglass drip pan
  • Engine room blower
  • Diesel engine, Yanmar 4JH3-TE, fresh water cooled, 75HP

STEERING

  •  Pedestal steering, Whitlock or equivalent
  •  SS 48” destroyer type wheel ( after cockpit )
  •  Emergency tiller
  •  SS rudder shaft

SPARS/RIGGING

  • Mainsail, dacron w/ 2 reef points and cover
  • 100 percent Yankee, dacron
  • Staysail, dacron
  • Sail bags for all sails

SAILS

  • Aluminum mast & boom, mast w/ electrical conduit & internal halyards
  • Standing rigging, stainless steel w/ swaged terminals.

INTERIOR

  • Teak joinery & cabinetry throughout
  • Teak & holly cabin sole
  • Teak veneer in all locker
  • White formica counters in head & galley
  • Teak framed mirror in head(s)
  • Interior teak handrails
  • V-berth filler if applicable
  • Cloth cushion covers on 4” cushions
  • Ice chest 4” foam, SS lined
  • Interior varnish, polyurethane satin
  • Stove alcove, SS lined
  • Easily removable head liner
  • Teak fiddles and teak trim on counters & tables
  • Solid teak doors & frames

ELECTRICAL

  • Three 120 amp hour 12 volt batteries & FRP boxes
  • Twelve 12v cabin lights overhead & eight reading lights
  • 12 volt electrical system w/ three way switch, Newmar electric panel w/ breakers, and voltmeter & ammeter
  • 110 volt electrical system w/ 50 amp shore power plug, electric panel w/breakers & voltmeter & ammeter, & 110 volt outlets throughout the yacht
  • International running lights to meet IMCO standards
  • 12 volt deck flood light
  • 12 volt anchor light
  • Completely bonded electrical system

PLUMBING

  • Two 90 gallon mild steel fuel tanks ( after cockpit )
  • Two SS water tanks, total of 200 gallons ( after cockpit )
  • Holding tank, FRP, 35 gallons
  • Hot water heater, 110 volt & engine heat exchanger
  • Manual marine heads
  • Hot & cold pressure water
  • One high capacity manual bilge pump
  • One heavy duty electric bilge pump
  • Bilge pump strainers
  • Sea cocks on all through hull
  • 11  Shower sump tanks w/ 12 volt pumps

top